Description

WARNING: Repeat Drive Brushed motors operated at 4S CANNOT be stalled for an extended period! The motor will overheat and let out smoke, sustaining permanent damage. These ESCs do not have active current limiting, so if the motor is stalled until failure, the FET driving that motor will also fail, permanently damaging the ESC. If this occurs, you will have to replace both the brushed motor and the ESC.

Testing showed that the ESC and motor can be damaged when stalling for as little as 7 seconds on 4S and 25 seconds on 3S. In every test case, the motor smoked first and stopped working before the ESC failed.

Features:

• NEW! Reduced size: 24x18x5mm
• Weight: 7g with wires
• Voltage
  • Recommended: 2-4S
  • Max: 6S (not recommended)
• Current: 2A continuous
• Center braking for better motor control
• Built in mixing (disabled by default)
  • Enable mixing by cutting the jumper near the i on the back of the board (shown in the last photo)
• Auto adjusts to PWM values between 800-1100μs for reverse and 1900-2200μs for forward
• Failsafe behavior will stop motors when signal is lost
• Integrated 5V 1.5A BEC output
  • BEC can power servos on 2-3S
  • BEC can power receivers on 2-4S
  • BEC should not be used for servos on 4S
  • BEC should not be used above 4S (cut red wires from CH1 servo connector)
• Pre-soldered connectors
  • Power: XT30U connecter to connect to a battery or power distribution board
  • Signal: 1 servo connector for Ch2 + 5v(BEC) + GND and a 1 pin CH1 signal connector

Package includes 1x Budget Ant Dual Brushed ESC